ABB DressPack IRB6650S Product Manual page 104

2 Installation
2.2.7.3 Fitting the cable package IRBDP SW2 CE
Continued
11
12
13
14
Continues on next page
104
Action
Spot welding applications only:
Run the weld power cable, slightly to the right
of the signal cable and hoses in order to facil-
itate the connecting of cables in the robot
base.
Fit the weld power cable to the cable holder
bracket axis 1 with its two locking nuts M6.
Spot welding applications only:
Fit the weld power cable to the rear of the
process plate, with two attachment screws
using the weld connector bracket.
Do not tighten the attachment screws at this
point.
Screws are supplied with the kit.
Fit the connectors to the customer plate and
process plate previously fitted to the connec-
tion plate, base.
Screws are supplied with the kit.
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
Tip
In order to get the weld power cable fitted in
the right position on the plate customer, first
connect the floor weld cable to the weld
power cable and use it as a guide.
Before tightening the weld power attachment
screws, make sure that the cable connector
is evenly positioned in the hole of the process
plate.
Tighten the weld power cable attachment
screws.
© Copyright 2004-2018 ABB. All rights reserved.
Note
Check that the weld power cable do not
end up between other cables and hoses.
B
xx0300000196
Parts (as seen from above):
• A: Weld power cable (behind
process plate)
• B: Weld connector bracket
• C: Process plate
• D: Screw holes in process plate
• E: Attachment screws M6x30
quality 8.8-A2F (2 pcs)
• F: Guide pins on weld connector
bracket
Tightening torque, brass couplings 1/2":
31Nm
Tightening torque, brass couplings 3/8":
17Nm
Shown in the figure in section
of cable package - IRBDP SW2 CE on
page 97.
Recheck all cables and hoses for
straining or twisting. Reroute if required!
Screw dimension: M6x20
The weld power attachments screws are
shown in figure above!
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
C
F
A
D
E
Location