ABB DressPack IRB6650S Product Manual page 181

12
13
IRBDP MH3 LE & IRBDP MH3 UE
1
2
3
4
5
6
7
Product manual - DressPack/SpotPack IRB 6650S
3HAC055424-001 Revision: C
2.3.4 Inspection during programming and test-running
Action
Make sure that the velcro straps is not too
tight. The cables should be able to twist
individually.
The straps shall be tight!
Make sure that no parts of the DressPack
are in contact with the surroundings.
Action
Inspect the DressPack upper arm installa-
tion before programming and test-running.
Make a check of the operating cycle of the
robot, to make sure that the movement
pattern of the wrist does not cause extens-
ive wear or strain of the cable package.
Make sure that the upper arm protective
hose does not get flattened during rotating
upper arm movements.
IRB 7600
Make sure the process cable package does
not rub against the sides of the wrist more
than absolutely necessary.
If any of the actions recommended above,
causes a change of the DressPack installa-
tion, it must be reinspected.
Make sure that the velcro straps is not too
tight. The cables should be able to twist in-
dividually.
The straps shall be tight.
Make sure that no parts of the DressPack
are in contact with the surroundings.
© Copyright 2004-2018 ABB. All rights reserved.
2 Installation
Note
B
A
xx0500001792
Parts:
• A: Straps
• B: Velcro straps
Note
See section Inspection, DressPack upper
arm on page 167.
If required, re-program the robot move-
ment pattern.
Flattening indicates an overstressed hose
and increases the risk of damaging the
DressPack upper arm.
The rubbing may result in the cable get-
ting stuck. When the package is released,
the retracting unit may snap back, poten-
tially causing damage to the equipment.
See section Inspection, DressPack upper
arm on page 167.
B
A
xx0500001792
Parts:
• A: Straps
• B: Velcro straps
Continues on next page
Continued
181