Subaru Legacy 2002 Service Manual page 2804

11. Roll Connector
A: REMOVAL
S802299A18
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
3) Remove instrument panel lower cover.
4) Disconnect airbag connector (AB3) and (AB8)
below steering column.
5) Remove driver's airbag module. <Ref. to
AB-12, Driver's Airbag Module.>
6) Remove steering wheel. <Ref. to PS-21,
REMOVAL, Steering Wheel.>
7) Remove steering column cover.
8) Remove screws, and then remove roll connec-
tor.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Check for the following, and replace damaged
parts with new parts.
¼ Combination switch and roll connector is
cracked or deformed.
D: ADJUSTMENT
1) Check that front wheels are positioned in
straight ahead direction.
2) Turn roll connector pin (A) clockwise until it
stops.
ROLL CONNECTOR
S802299
G5M0312
B5M1074
S802299A11
S802299A10
S802299A01
3) Turn roll connector pin (A) counterclockwise
approximately 2.65 turns until " " marks are
aligned.
AB-19
Airbag System