Subaru Legacy 2002 Service Manual page 2788

Hide thumbs Also See for Legacy 2002:
Table of Contents

Advertisement

B: CAUTION
S802001A03
¼ When servicing a vehicle, be sure to turn the
ignition switch OFF, disconnect the ground cable
from the battery, and wait for more than 20 sec-
onds before starting work.
¼ The airbag system is fitted with a backup power
source. If the airbag system is serviced within 20
seconds after the ground cable is disconnected, it
may inflate.
¼ If sensors, airbag module, airbag control
module, pretensioner, and harness are deformed
or damaged, replace them with new genuine parts.
¼ When checking the system, be sure to use a
digital circuit tester.
Use of an analog circuit tester may cause the air-
bag to activate erroneously.
GENERAL DESCRIPTION
¼ When checking, use a test harness. Do not
directly apply the tester probe to any connector
terminal of the airbag.
G5M0292
G5M0291
¼ Do not check continuity of either of the airbag
modules for driver, passenger or side, or preten-
sioner.
AB-3
Airbag System
G5M0293
G5M0294
G5M0302

Advertisement

Table of Contents
loading

Table of Contents