Subaru Legacy 2002 Service Manual page 2802

AIRBAG CONTROL MODULE
Airbag System
9. Airbag Control Module
S802302
A: REMOVAL
S802302A18
CAUTION:
¼ Do not disassemble the airbag control mod-
ule.
¼ If the airbag control module is deformed or if
water damage is suspected, replace the airbag
control module with a new genuine part.
¼ Do not drop the airbag control module.
¼ After removal, keep the airbag control mod-
ule on a dry, clean surface away from moisture,
heat, and dust.
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
3) Remove console box. <Ref. to EI-34,
REMOVAL, Console Box.>
4) Disconnect connector from airbag control mod-
ule.
5) Using T40 TORX bit (Tamper resistant type),
remove four TORX bolts in the order shown in the
figure.
S5M0219A
B: INSTALLATION
S802302A11
CAUTION:
Use new TORX bolts during re-assembly.
Install in the reverse order of removal.
C: INSPECTION
S802302A10
Check for the following, and replace damaged
parts with new parts.
¼ Control module, connector, and mounting
bracket are damaged.
¼ Airbag is deployed.
¼ Side airbag is deployed.
AB-17