Subaru Legacy 2002 Service Manual page 2813

Hide thumbs Also See for Legacy 2002:

Table of Contents

DISPOSAL OF AIRBAG MODULE (DEPLOYING AFTER REMOVAL FROM

Airbag System

The deployment tool should be kept shorted

until just before deployment of the airbag mod-

7) Connect adapter A (deployment) connector

(2D) to airbag module.

8) Install airbag module with pad side facing

upward on 14 inch or greater size wheel with the

9) Put three tires without the wheel on the tire

installed with the airbag module. Put on an addi-

tional tire with the wheel on top, and then fasten

them tight with rope.

10) Move the battery at least 5 m (16 ft) from

vehicle, and secure the nearby area. Connect the

deployment tool alligator clip to the battery minus

11) Connect the other terminal of the deployment

tool to the battery positive (+) terminal. Then,

deploy the airbag module.

¼ After deployment, the airbag module will be

especially hot. Leave it unattended for 40

minutes, and then discard it.

¼ Do not let water get on the deployed airbag

12) Wrap the deployed airbag module in an air-

tight vinyl bag, and discard it.

3. AIRBAG MODULE (SIDE)

1) Turn ignition switch OFF.

2) Disconnect the ground cable from the battery,

and wait for at least 20 seconds before starting

S802574A1603

Chapters

Table of Contents