Subaru Legacy 2002 Service Manual page 2829

Seat Belt System
8) Extend the deployment tool to the limit, and
make sure that vehicle is empty. Close all
windows, sunroof, and rear gate completely.
9) Move the battery at least 5 m (16 ft) from the
vehicle, and secure the nearby area. Connect the
deployment tool alligator clip to the battery minus
terminal.
10) Connect the other terminal of deployment tool
to the battery plus terminal. Then deploy the pre-
tensioner.
CAUTION:
¼ After deployment, pretensioner is especially
hot. Leave it unattended for 40 minutes.
¼ Do not let water get on the deployed preten-
sioner.
11) Remove outer belt (front). <Ref. to SB-8,
REMOVAL, Front Seat Belt.>
12) Wrap the deployed pretensioner in an airtight
vinyl bag, and then discard it.
DISPOSAL OF PRETENSIONER
B5M1068
G5M0531
B5M0500
SB-14
2. DEPLOYING AFTER REMOVAL FROM
VEHICLE
S801305A1602
1) Fold backrest all the way forward, then move
front seat all the way forward.
2) Turn ignition switch OFF, disconnect the ground
cable from the battery, and wait for more than 20
seconds before starting work.
3) Remove outer belt (front). <Ref. to SB-8,
REMOVAL, Front Seat Belt.>
4) Cut off seat belt as close to retractor as pos-
sible.
5) Short terminal to alligator clip furnished as a
deployment tool.
6) Connect the deployment tool and adapter A
(deployment).
Deployment tool: (Part No. 98299PA030)
Adapter A (deployment) : (Part No.
98299FAC030)
CAUTION:
The deployment tool should be kept shorted
until just before deployment of the preten-
sioner.
7) Connect adapter A (deployment) connector
(2D) and pretensioner yellow connector.
B5M0494
S5M0309A