Subaru Legacy 2002 Service Manual page 2798

PASSENGER'S AIRBAG MODULE
Airbag System
5. Passenger's Airbag Module
S802308
A: REMOVAL
S802308A18
CAUTION:
Refer to "CAUTION" in General Description
before handling the airbag module. <Ref. to
AB-3, CAUTION, General Description.>
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
3) Remove glove box. <Ref. to EI-32, REMOVAL,
Glove Box.>
4) Disconnect airbag connector (A), and then
detach airbag connector from support beam
bracket.
5) Remove three bolts, and then carefully remove
airbag module.
B5M0681A
6) Refer to "CAUTION" for handling of a removed
airbag module. <Ref. to AB-3, CAUTION, General
Description.>
B: INSTALLATION
S802308A11
Install in the reverse order of removal.
CAUTION:
Do not allow harness and connectors to inter-
fere or get tangled up with other parts.
C: INSPECTION
S802308A10
CAUTION:
Refer to "CAUTION" in General Description
before handling the airbag module. <Ref. to
AB-3, CAUTION, General Description.>
Check for the following, and replace damaged
parts with new parts.
¼ Airbag module, harness, connector, and mount-
ing bracket are damaged.
AB-13