Subaru Legacy 2002 Service Manual page 2915

Glass/Windows/Mirrors
C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts
of stabilizer, upper stopper, and sash are loose and
door glass is raised so that it is in contact with
weatherstrip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten regulator B-channel in a
position slightly lower than midpoint of slotted hole.
3) Lower door glass 10 to 15 mm (0.39 to 0.59 in)
from fully closed position. While applying outward
pressure of 45±5 N (4.59±0.51 kgf, 10.12±1.12 lb)
(F) to upper edge of glass above midpoint of two
outer stabilizers, press inner stabilizer at 10±5 N
(1.02±0.51 kgf, 2.25±1.12 lb) until it just touches
the glass, then secure it.
4) For adjustment of clearance between front and
rear glasses, loosen nuts (A) and (B), and move
glass sash back and forth until clearance becomes
the value shown.
FRONT DOOR GLASS
S905452A01
G5M0421
B5M0731A
5) For adjustment of upper and lower ends of cen-
ter pillar, loosen adjusting nut (A) of B-channel (B).
6) Adjust so that upper and lower ends of center
pillar are the same size.
GW-14
B5M0730A
B5M0729A
B5M0728A