Subaru Legacy 2002 Service Manual page 2812

DISPOSAL OF AIRBAG MODULE (DEPLOYING AFTER REMOVAL FROM
10) Put three tires without the wheel on the tire
installed with the airbag module. Put on an addi-
tional tire with the wheel, and then fasten them
tight with rope.
11) Move the battery at least 5 m (16 ft) from
vehicle, and secure the nearby area. Connect the
deployment tool alligator clip to the battery minus
terminal.
12) Connect the other terminal of the deployment
tool to the battery positive (+) terminal. Then,
deploy the airbag module.
CAUTION:
¼ After deployment, the airbag module will be
especially hot. Leave it unattended for 40
minutes, and then discard it.
¼ Do not let water get on the deployed airbag
module.
VEHICLE)
13) Wrap the deployed airbag module in an air-
tight vinyl bag, and discard it.
G5M0536
2. AIRBAG MODULE (PASSENGER)
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
3) Remove airbag module. <Ref. to AB-13,
REMOVAL, Passenger's Airbag Module.>
4) Bundle three wire automotive harnesses [each
with a sectional area of 1.25 mm
or more], and route them through the airbag mod-
ule bracket (A). Then, twist them for added
strength.
G5M0537
5) Short terminal to alligator clip furnished as
deployment tool.
6) Connect the deployment tool and adapter A
(deployment).
Deployment tool: (Part No. 98299PA030)
Adapter A (deployment): (Part No.
G5M0531
98299FC030)
AB-27
Airbag System
G5M0532
S802574A1602
2
(0.00194 sq in)
S5M0312A