Subaru Legacy 2002 Service Manual page 2796

INSPECTION LOCATIONS AFTER A COLLISION
7. SIDE AIRBAG SENSOR
If the side section of vehicle as shown in the figure
is damaged:
Check for the following, and replace damaged
parts with new parts.
¼ Side airbag sensor is cracked or deformed.
¼ Mounting bracket is cracked or deformed.
¼ Connector is scratched or cracked.
¼ Side airbag is deployed. (operating side)
8. SIDE AIRBAG SENSOR HARNESS
S802306A1008
Check for the following, and replace damaged
parts with new parts.
¼ Harness is open, lead wire is exposed, and cor-
rugated tube is noticeably cracked.
¼ Connector is scratched or cracked.
9. MAIN HARNESS
Check for the following, and replace damaged
parts with new parts.
¼ Harness is open, lead wire is exposed, and cor-
rugated tube is noticeably cracked.
¼ Connector is scratched or cracked.
10. ROLL CONNECTOR
Check for the following, and replace damaged
parts with new parts.
¼ Combination switch or steering roll connector is
cracked or deformed.
S802306A1007
B5M0514
S802306A1009
S802306A1010
11. STEERING SHAFT
Check for the following, and replace damaged
parts with new parts.
The clearance between capsule (A) and tip of col-
umn bracket (B) on steering column upper side
should be within specifications.
Specifications:
Clearance between capsule and tip of col-
umn bracket L
More than 1.3 mm (0.051 in)
If necessary, replace them with new parts.
AB-11
Airbag System
S802306A1011
B5M0677A