Subaru Legacy 2002 Service Manual page 2797

Airbag System
4. Driver's Airbag Module
A: REMOVAL
S802307A18
CAUTION:
Refer to "CAUTION" in General Description
before handling the airbag module. <Ref. to
AB-3, CAUTION, General Description.>
1) Position front wheels straight ahead. (After
moving a vehicle more than 5 m (16 ft) with front
wheels positioned straight ahead, make sure that
the vehicle moves straight ahead).
2) Turn ignition switch OFF.
3) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
4) Using TORX BIT T30, remove two TORX
bolts on side of steering wheel.
5) Disconnect airbag connector on back of airbag
module, and then remove airbag module.
6) Refer to "CAUTION" for handling of a removed
airbag module. <Ref. to AB-3, CAUTION, General
Description.>
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Do not allow harness and connectors to inter-
fere or get tangled up with other parts.
DRIVER'S AIRBAG MODULE
S802307
H5M0662A
H5M0664
S802307A11
AB-12
C: INSPECTION
CAUTION:
Refer to "CAUTION" in General Description
before handling the airbag module. <Ref. to
AB-3, CAUTION, General Description.>
Check for the following, and replace damaged
parts with new parts.
¼ Airbag module, harness, connector, and mount-
ing bracket are damaged.
S802307A10