Subaru Legacy 2002 Service Manual page 2770

Hide thumbs Also See for Legacy 2002:

Table of Contents

13. Condenser

1) Using refrigerant recovery system, discharge

refrigerant. <Ref. to AC-22, OPERATION, Refrig-

erant Recovery Procedure.>

2) Disconnect ground cable from battery.

3) Remove duct (A).

4) Disconnect high-pressure hose (A) and low-

pressure hose (B) from condenser.

HVAC System (Heater, Ventilator and A/C)

5) Remove radiator bracket (A).

6) Remove 2 bolts. While lifting condenser, pull it

out through the space between the radiator and the

radiator panel.

Be careful not to damage condenser fins. If a

damaged fin is found, repair it using a thin

screwdriver.

If condenser is replaced, add appropriate

amount of compressor oil to the compressor.

<Ref. to AC-28, REPLACEMENT, Compressor

B: INSTALLATION

1) Install in the reverse order of removal.

Replace O-rings on hoses or pipes with new

ones, and then apply compressor oil. Confirm

that lower guide of condenser has been fitted

into holes on radiator panel.

Chapters

Table of Contents