Subaru Legacy 2002 Service Manual page 2844

11. Headlight Assembly
A: REMOVAL
S914409A18
1) Disconnect ground cable from battery.
2) Remove duct (A) (when right side headlight is
removed).
3) Disconnect headlight bulb connector.
4) Remove three bolts and disconnect connectors,
and then detach headlight assembly.
B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
1. HEADLIGHT AIMING
CAUTION:
Turn off the light before adjusting headlight
aiming. If the light is necessary to check
aiming, do not turn on for more than two min-
utes.
HEADLIGHT ASSEMBLY
S914409
B6M1186A
B6M1652
B6M1653
S914409A11
S914409A01
S914409A0101
NOTE:
Before checking the headlight aiming, be sure of
the following:
¼ The area around the headlight has not sustained
any accident, damage or other type of deformation.
¼ Vehicle is parked on level ground.
¼ The inflation pressure of tires is correct.
¼ Vehicle's gas tank is fully charged.
¼ Bounce the vehicle several times to normalize
the suspension.
¼ Make certain that someone is seated in the driv-
er's seat.
Turn the headlights on and then adjust the low
beam pattern to the following positions on the
screen.
NOTE:
¼ Set the headlight leveler switch to "0" position.
¼ Adjust vertical aim (A) first, then horizontal aim
(B).
LI-13
Lighting System
B6M1654A