Seats
D: ASSEMBLY
S908343A02
1. STANDARD
S908343A0201
1) Assemble in the reverse order of disassembly.
NOTE:
¼ Do not contaminate or damage cover.
¼ While installing hog rings, prevent seat from get-
ting wrinkled.
2) Attach seat cover end hole to hinge inner. (Only
non-tilt type standard seat)
2. POWER
S908343A0202
1) Assemble in the reverse order of disassembly.
NOTE:
¼ Do not contaminate or damage cover.
¼ While installing hog rings, prevent seat from get-
ting wrinkled.
¼ Make sure the connector is firmly connected.
¼ Make sure the wire harness is not pinched.
2) Attach seat cover end hole to hinge inner. (Only
non-tilt type standard seat)
Tightening torque:
Refer to COMPONENT in General
Description.
<Ref. to SE-2, FRONT SEAT,
COMPONENT, General Description.>
FRONT SEAT
SE-16