Subaru Legacy 2002 Service Manual page 2972

Hide thumbs Also See for Legacy 2002:

Table of Contents

3. Combination Meter

1) Disconnect ground cable from battery.

2) Set tilt steering at the lowest position.

3) Disconnect each electrical connector to remove

front cover (A) and switch panel (B).

4) Loosen screws (C) to remove center panel (D).

5) Remove meter visor (E).

The following illustration is for LHD model. The

layout for RHD model is symmetrically opposite.

6) Remove screws of combination meter to pull

out the meter toward you.

COMBINATION METER ASSEMBLY

7) Remove connector in the upper area of combi-

nation meter to remove meter.

¼ Be careful not to damage meter or instru-

¼ Pay particular attention to avoid damaging

the meter glass.

Instrumentation/Driver Info

Chapters

Table of Contents