Subaru Legacy 2002 Service Manual page 2801

SIDE AIRBAG HARNESS
Airbag System
8. Side Airbag Harness
S802309
A: REMOVAL
S802309A18
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery,
and wait for at least 20 seconds before starting
work.
3) Remove front seat. <Ref. to SE-7, REMOVAL,
Front Seat.>
4) Remove console box. <Ref. to EI-34,
REMOVAL, Console Box.>
5) Roll up floor mat, and then disconnect two
12-pin yellow connectors from airbag control mod-
ule.
6) Disconnect connector from side airbag sensor.
<Ref. to AB-18, REMOVAL, Side Air Bag Sensor.>
7) Detach clips, and then remove side airbag har-
ness.
B5M0679
B: INSTALLATION
S802309A11
Install in the reverse order of removal.
C: INSPECTION
S802309A10
Check for the following, and replace damaged
parts with new parts.
¼ Harness and/or connector is damaged.
AB-16