Subaru Legacy 2002 Service Manual page 2989

Seats
5) Remove two bolts at rear side of seat rail.
6) Move seat to full rear end.
7) Remove two bolts at front side of seat rail.
8) Disconnect ground cable from battery.
CAUTION:
¼ Wait for 20 seconds or more after discon-
necting the battery.
¼ The airbag system has a backup power
source. The airbag might deploy if you do not
wait for 20 seconds or more before starting.
9) Disconnect side airbag connector under the
seat. (Side airbag equipped vehicle)
10) Disconnect connectors of seat heater and
seat belt warning. (Seat heater equipped vehicle)
11) Remove front seat from vehicle.
CAUTION:
When removing seat form vehicle, take care
not to damage body, seat, or trim.
FRONT SEAT
B: INSTALLATION
1. STANDARD
1) Install in the reverse order of removal.
2) Place slide rail rear inner on location bolts.
H5M0705
3) Tighten the four bolts of slide rail.
CAUTION:
Confirm that seat can move smoothly and be
locked securely at any position.
2. POWER
1) Install in the reverse order of removal.
2) Place slide rail rear inner on location bolts.
G5M0344
3) Tighten the four bolts of slide rail.
CAUTION:
Confirm that seat can move smoothly.
Tightening torque:
Refer to COMPONENT in General
Description.
<Ref. to SE-2, FRONT SEAT,
COMPONENT, General Description.>
B5M1073
SE-8
S908343A11
S908343A1101
S908343A1102
B5M0661A
B5M0661A