Subaru Legacy 2002 Service Manual page 2820

Hide thumbs Also See for Legacy 2002:

Table of Contents

GENERAL DESCRIPTION

Seat Belt System

¼ Before starting, turn the ignition switch OFF, dis-

connect the battery ground cable and wait for 20

seconds or more.

¼ The pretension system has a backup power

source. The pretensioner might deploy if you do

not wait for 20 seconds or more before starting

¼ Do not drop or apply any impact to the preten-

¼ If oil, grease, or water gets on the pretensioner,

wipe it off immediately with a dry cloth.

¼ Do not expose the pretensioner to high tempera-

ture or flame.

¼ Do not allow current to flow through or voltage

to reach the pretensioner. Do not use a circuit

tester to check resistance of the pretensioner.

¼ Do not disassemble or attempt to repair the pre-

tensioner. If it is dented, cracked, or deformed,

replace it with a new one.

¼ Do not use the airbag or pretensioner parts from

other vehicles. Always replace parts with new parts

¼ When handling a seat belt with a deployed

pretensioner, wear gloves and goggles. Wash your

hands afterwards.

¼ Do not re-use a seat belt with a deployed pre-

tensioner again.

¼ Be sure to deploy pretensioner before disposal.

<Ref. to SB-13, OPERATION, Disposal of Preten-

¼ If the material gets in your eyes or on your skin

during deployment, wash it away with clean water,

and then consult a doctor.

Chapters

Table of Contents