Subaru Legacy 2002 Service Manual page 2971

Instrumentation/Driver Info
9. CHECK COMBINATION METER PRINTED CIRCUIT
(A) Combination meter connector (16-poles): To B: (i11)
(B) Combination meter printed circuit connector (5-poles): To CFL inverter harness
No.
1 CHECK COMBINATION METER PRINTED
CIRCUIT.
1) Turn ignition switch OFF.
2) Remove combination meter. <Ref. to IDI-
15, REMOVAL, Combination Meter Assem-
bly.>
3) Disconnect connector from combination
meter.
4) Disconnect CFL inverter harness connector
(5-poles) from behind the meter.
5) Remove CFL inverter from combination
meter. <Ref. to IDI-17,
ELECTROLUMINESCENT, DISASSEMBLY,
Combination Meter Assembly.>
6) Measure resistance between printed circuit
connector (B) and combination meter connec-
tor (A).
Connector & terminal
Printed circuit connector (B) No. 1 —
Combination meter connector (A) No.
7:
Printed circuit connector (B) No. 2 —
Combination meter connector (A) No.
7:
2 CHECK COMBINATION METER PRINTED
CIRCUIT.
1) Connect combination meter connectors to
instrument panel harness. (With CFL inverter
removed.>
2) Turn ignition switch ON.
3) Measure voltage between printed circuit
connector (B) terminals.
Connector & terminal
Printed circuit connector (B) No. 1—
No. 5:
COMBINATION METER SYSTEM
Step
Is the resistance less than
1 Ω?
Is the voltage more than
10 V?
IDI-14
S907607A1010
Check Yes
Go to step 2.
Replace CFL
assembly (light,
harness and
inverter).
B6M1623A
No
Replace combina-
tion meter printed
circuit.
Replace combina-
tion meter printed
circuit.