Subaru Legacy 2002 Service Manual page 1242

8. Data Link Connector
A: NOTE
S048505A15
1) This connector is used both for OBD-II general scan tools and the Subaru Select Monitor.
2) Terminal No. 6 to No. 8 of the data link connector is used for the Subaru Select Monitor signal.
CAUTION:
Do not connect any scan tools other than the OBD-II general scan tools and the Subaru Select
Monitor, because the circuit for the Subaru Select Monitor may be damaged.
Terminal No.
1 Power supply
2 Blank
3 Blank
4 Blank
5 Blank
6 Line end check signal 1
7 Blank
8 Line end check signal 2
*: Circuit only for Subaru Select Monitor
DATA LINK CONNECTOR
S048505
H2M1280
Contents
EN(H6)-35
Terminal No.
9 Blank
10 K line of ISO 9141 CARB
11 Blank
12 Ground
13 Ground
14 Blank
15 Blank
16 Blank
Engine (DIAGNOSTICS)
Contents