Subaru Legacy 2002 Service Manual page 1174

10) Disconnect grommet (A) from toe board.
NOTE:
From inside compartment, push grommet into
hole.
11) Pull out the cable from the toe board hole.
12) Disconnect accelerator cable bushing from
accelerator pedal lever.
(A) Slot-type screwdriver
13) Disconnect accelerator cable stopper (A) from
bracket.
14) Separate accelerator cable and bracket.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
¼ If cable clamp is damaged, replace it with a
new one.
¼ Never fail to cover outer cable end with boot.
¼ Be careful not to kink accelerator cable.
¼ Always use new clevis pins.
ACCELERATOR PEDAL
B4M1740B
B4M1741B
B4M1742B
S147005A11
SP(H6)-5
Accelerator cable lock nut tightening torque:
12 N·m (1.2 kgf-m, 9 ft-lb)
Speed Control Systems