Transmission Mounting System - Subaru Forester 2001 Service Manual

4. Transmission Mounting
System
S503233
A: REMOVAL
S503233A18
1. PITCHING STOPPER
1) Disconnect battery ground terminal.
2) Remove the cleaner case. (Non-turbo model)
<Ref. to IN(SOHC)-7, REMOVAL, Air Cleaner
Case.>
3) Remove intercooler. (Turbo model) <Ref. to
IN(DOHC TURBO)-10, REMOVAL, Intercooler.>
4) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION
RUBBER
S503233A1802
1) Disconnect battery ground terminal.
2) Jack-up vehicle and support it with sturdy
racks.
3) Remove the front, center, rear exhaust pipes
and muffler. (Non-turbo model)
With OBD:
<Ref. to EX(SOHC)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(SOHC)-9, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(SOHC)-11,
REMOVAL, Muffler.>
Without OBD:
<Ref. to EX(SOHCw/oOBD)-6, REMOVAL, Front
Exhaust Pipe.>, <Ref. to EX(SOHCw/oOBD)-10,
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(SOHCw/oOBD)-12, REMOVAL, Muffler.>
CAUTION:
When removing exhaust pipes, be careful each
exhaust pipe does not drop out.
4) Remove center, rear exhaust pipes and muffler.
<Ref. to EX(DOHC TURBO)-9, REMOVAL, Center
Exhaust Pipe.>, <Ref. to EX(DOHC TURBO)-14,
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(DOHC TURBO)-15, REMOVAL, Muffler.>

TRANSMISSION MOUNTING SYSTEM

S503233A1801
S2M0126
MT-39
Manual Transmission and Differential
5) Remove the heat shield cover. (If equipped)
6) Set the transmission jack under the transmis-
sion body.
CAUTION:
Always support transmission case with a
transmission jack.
7) Remove the rear crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
2) Install the cleaner case. (Non-turbo model)
<Ref. to IN(SOHC)-7, INSTALLATION, Air Cleaner
Case.>
S2M0215
G2M0831
S503233A11
S503233A1101
S2M0126C