Transmission Mounting System - Subaru IMPREZA 2002 Service Manual

I
TRANSMISSION MOUNTING SYSTEM
AUTOMATIC TRANSMISSION
1O.Transmission Mounting Sys-
A: REMOVAL
1. PITCHING STOPPER
1 ) Disconnect the ground terminal from battery.
2) Remove the air intake duct. (Non-turbo model)
<Ref. to IN(S0HC)-7, REMOVAL, Air Intake Duct.>
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(S0HC)-6, REMOVAL, Air Cleaner
Case.>
4) Remove the intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-1 0, REMOVAL, Intercooler.>
5) Remove the pitching stopper.
tem
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground terminal from battery.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the front, center, rear exhaust pipes
and muffler. (Non-turbo model)
<Ref. to EX(S0HC)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(S0HC)-9, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(S0HC)-11, RE-
MOVAL, Muffler.>
4) Remove the center, rear exhaust pipes and muf-
fler. (Turbo model) <Ref. to EX(D0HC TURBO)-8,
REMOVAL, Center Exhaust Pipe.>, <Ref. to
EX(D0HC TURBO)-1 3, REMOVAL, Rear Exhaust
Pipe.>, <Ref. to EX(D0HC TURBO)-14, REMOV-
AL, Muffler.>
CAUTION:
When removing the exhaust pipes, be careful
each exhaust pipe does not drop out.
5) Remove the heat shield cover. (If equipped)
6) Set the transmission jack under the transmis-
sion.
CAUTION:
Make sure that the support plates of trans-
mission jack don't touch the oil pan.
7) Remove the crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T I : 50 N.m (5.1 kgf-m, 37 ff-lb)
T2: 58 N.m (5.9 kgf-m, 43 ft-lb)
2) Install the air intake duct and cleaner case. (Non-
turbo model) <Ref. to IN(S0HC)-7, REMOVAL, Air
Intake Duct.>, <Ref. to IN(S0HC)-6, REMOVAL,
Air Cleaner Case.>
3) Install the intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-1 0, REMOVAL, Intercooler.>
AT-25