Subaru Legacy 2002 Service Manual page 1195

Starting/Charging Systems
6) Remove shaft assembly and overrunning clutch
as a unit.
CAUTION:
Before removal, confirm the following:
¼ Lever direction
¼ Internal gear assembly position
(A) Lever
(B) Shaft ASSY
(C) Overrunning clutch
(D) Internal gear ASSY
7) Remove overrunning clutch from shaft assem-
bly as follows:
(1) Remove stopper from ring by lightly tapping
the stopper with an appropriate tool (such as a
socket).
(2) Remove ring, stopper and clutch from shaft.
(A) Socket wrench
(B) Ring
(C) Shaft
(D) Stopper
STARTER
2. BRUSH HOLDER
Slightly open the metal fitting holding the insulating
plate to the brush holder. Remove the insulating
plate.
NOTE:
The brush and spring can be easily removed from
the brush holder at this time.
B2M4458B
(A)
(B)
(C)
B2M4769A
SC(H6)-8
S149012A0602
Brush holder
Insulating plate
Metal fitting
H6M0497B