Subaru Legacy 2002 Service Manual page 1194

2) Remove bolts which hold switch assembly, and
remove switch assembly, plunger and plunger
spring from starter as a unit.
CAUTION:
Be careful because pinion gap adjustment
washer may sometimes be used on the mount-
ing surface of switch assembly.
(A) Switch ASSY
(B) Plunger
3) Remove both through-bolts and brush holder
screws, and detach rear bracket and brush holder.
CAUTION:
Before removal, confirm the attachment loca-
tions of brush holder and rear bracket.
(A) Brush holder
(B) Rear bracket
STARTER
4) Remove armature and yoke. Ball used as a
bearing will then be removed from the end of arma-
ture.
CAUTION:
Be sure to mark an alignment mark on yoke
and front bracket before removing yoke.
B2M4455A
(A)
(B)
(C)
(D)
5) Remove packing A, three planetary gears,
packing B and plate.
CAUTION:
Before removal, confirm the inserting location
of packing A.
H6M0494B
(A)
(B)
(C)
(D)
SC(H6)-7
Starting/Charging Systems
Armature
Ball
Yoke
Front bracket
Packing A
Planetary gear
Plate
Packing B
H6M0495D
B2M4793A