Subaru Legacy 2002 Service Manual page 1202

Hide thumbs Also See for Legacy 2002:

Table of Contents

Front bracket

3) Unsolder connection between rectifier and sta-

tor coil to remove stator coil.

Finish the work rapidly (less than three sec-

onds) because the rectifier cannot withstand

heat very well.

4) Remove screws which secure IC regulator to

rear cover, and unsolder connection between IC

regulator and rectifier to remove IC regulator.

5) Remove the brushes by unsoldering at the pig-

6) Remove the nut and insulating bushing at ter-

minal B, and remove rectifier.

Assemble in the reverse order of disassembly.

1) Pulling up brush

Before assembling, press the brush down into the

brush holder with your finger and secure in that

position by passing a [2 mm (0.08 in) dia. length 4

to 5 cm (1.6 to 2.0 in)] wire (A) through the hole

shown in the figure.

Be sure to remove the wire after reassembly.

Starting/Charging Systems

Chapters

Table of Contents