Control Vatve Body - Subaru IMPREZA 2002 Service Manual

I
AUTOMATIC TRANSMISSION
CONTROL VALVE BODY
16.Control Valve Body
A: REMOVAL
1) Lift-up the vehicle.
2) Clean the transmission exterior.
3) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N.m (2.5 kgf-m, 18.7 ff-16)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
4) Remove the oil pan.
NOTE:
Remove and clean the magnet.
Remove the old gasket on the oil pan and trans-
mission case completely.
5) Disconnect the duty solenoids and ATF temper-
ature sensor connectors. Remove the connectors
from clip and disconnect the connectors.
B2M2269
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
6) Remove the control valve. When removing the
control valve body, be careful not to interfere with
transfer duty solenoid wiring.
I1 03;
AT-37