Transfer Duty Solenoid And Valve Body - Subaru Impreza 2003 Service Manual

TRANSFER DUTY SOLENOID AND VALVE BODY

AUTOMATIC TRANSMISSION
18.Transfer Duty Solenoid and
Valve Body
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the air cleaner case. (2.0 L Non-turbo
and 2.5 L models)
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
4) Remove intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-10, REMOVAL, Intercool-
er.>
5) Remove the pitching stopper.
6) Remove the front exhaust pipe with center ex-
haust pipe. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>
7) Remove center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>
8) Remove the rear exhaust pipe and muffler.
(Non-turbo model)
<Ref. to EX(H4SO)-10, REMOVAL, Rear Exhaust
Pipe.> and <Ref. to EX(H4SO)-12, REMOVAL,
Muffler.>
(Turbo model)
<Ref. to EX(H4DOTC)-14, REMOVAL, Rear Ex-
haust Pipe.> and <Ref. to EX(H4DOTC)-15, RE-
MOVAL, Muffler.>
9) Raise the vehicle and drain the ATF.
10) Remove the heat shield cover. (If equipped)
11) Remove the propeller shaft. <Ref. to DS-15,
REMOVAL, Propeller Shaft.>
12) Remove the transmission rear crossmember.
(1) Support the transmission using a transmis-
sion jack and raise slightly.
(2) Remove the bolts and nuts as shown in the
figure.
AT-00679
13) Remove the rear vehicle speed sensor.
4AT-66
(B)
(C)
(A) Oil pan
(B) Drain plug
(C) Deferential oil drain plug
(A)
AT-00016
AT-00024
AT-00082