Oil Pressure Switch - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:

Table of Contents

7. Oil Pressure Switch

1) Set vehicle on the lift.

2) Disconnect battery ground cable.

3) Lift-up the vehicle.

4) Remove under cover.

5) Disconnect terminal from oil pressure switch.

6) Remove oil pressure switch.

B: INSTALLATION

1) Apply fluid packing to oil pressure switch

OIL PRESSURE SWITCH

Fluid packing:

THREE BOND 1324 or equivalent

2) Install oil pressure switch.

Tightening torque:

25 N·m (2.5 kgf-m, 18.1 ft-lb)

3) Connect terminal of oil pressure switch.

4) Install under cover.

C: INSPECTION

Make sure oil does not leak or seep from where the

oil pressure switch is installed.

Table of Contents