Vehicle Speed Sensor (Mt) - Subaru Impreza 2002 Service Manual

MANUAL TRANSMISSION AND DIFFERENTIAL
4. Vehicle Speed Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the intercooler. <Ref. to IN(TURBO)-
10, REMOVAL, Intercooler.>
3) Disconnect the vehicle speed sensor connector.
4) Remove the vehicle speed sensor.
B: INSTALLATION
1) Align the tip end of vehicle speed sensor key
with key groove on the end of speedometer shaft,
and then install.
Tightening torque:
5.9 N·m (0.6 kgf-m, 4.4 ft-lb)
NOTE:
• Ensure the sensor mounting hole is clean and
free of foreign matter.
• Discard the vehicle speed sensor and after re-
moval, replace with a new one.
2) Connect the connector to vehicle speed sensor.
3) Install the intercooler. <Ref. to IN(TURBO)-11,
INSTALLATION, Intercoooler.>
VEHICLE SPEED SENSOR
C: INSPECTION
Inspect that the speedometer is normally operated,
because vehicle speed sensor cannot be inspected
as single part. If it is not normally operated, inspect
the combination meter system. <Ref. to IDI-5, IN-
SPECTION, Combination Meter System.>
TR0635
TR0635
6MT-34