Reservation Of Tool Wear Compensation (Lathe System); Outline - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function

14.5 Reservation of Tool Wear Compensation (Lathe System)

14.5 Reservation of Tool Wear Compensation (Lathe System)

14.5.1 Outline

Setting values of tool wear compensation memory can be reserved using the reserved tool wear compensation memory. By
reflecting the reserved value of tool wear compensation memory with the PLC signal, tool wear compensation which is set
during the automatic operation can be enabled at the same time. Reserved tool wear compensation memory can be set only
from the custom API. Reserved tool wear compensation memory can be set only from custom API. The parameter setting and
the PLC signal enable users to reserve tool wear compensation.
This function is enabled by the following procedure.
(1) Set "#8140 Reserve T wear com" to "1" and turn ON the power again.
(2) After the power is turned ON again, turn ON "Reservation of tool wear compensation" signal (Y1CB8).
Reservation of tool wear
compensation
Setting of reserved tool wear
compensation memory
- Custom API
Setting of tool wear
compensation memory
- Mitsubishi Electric standard
screen
- Custom API
- Compensation data input by
program
- Input/Output
- System variables
- PLC window
- Manual tool length
measurement 1
- Manual tool length
measurement 2
- Automatic tool length
measurement
(*1) This function supports the following types of tool wear compensation memories.
Tool wear compensation memory
Tool nose wear compensation amount for 1st
axis (normally X axis)
Tool nose wear compensation amount for 2nd
axis (normally Z axis)
Tool wear compensation amount for additional
axis
Tool wear compensation amount for 2nd addi-
tional axis
Tool nose radius wear compensation amount
Reserved tool wear
Setting
compensation
memory (*1)
Reflected by the PLC signal
Setting
compensation
memory (*1)
Reserved tool wear compensation memory
Reserved tool nose wear compensation amount
for 1st axis (normally X axis)
Reserved tool nose wear compensation amount
for 2nd axis (normally Z axis)
Reserved tool wear compensation amount for
additional axis
Reserved tool wear compensation amount for
2nd additional axis
Reserved tool nose radius wear compensation
amount
589
Tool wear
Compen-
sation
starts
IB-1501668-B