Schlage PIB300 User Manual page 1277

Erasing the
HandPunch
Setup and User
Database
NOTE
Perform the following steps to erase both the configuration data and the user database.
1. With system power OFF, set both switches 4 and 5 ON.
2. Turn system power ON and wait 5 seconds.
3. Turn both switches 4 and 5 OFF.
Before putting the HandPunch into service ensure DIP switches 4 and 5 are both OFF.
If switches 4 and 5 are not off, the next time the HandPunch's power is cycled the
HandPunch's memory will be erased.
HandPunch 200 Manual
55