Schlage PIB300 User Manual page 1293

If you encounter problems while performing any of the following tests, review the installation
instructions and this guide and correct any problems.
Mechanical test
1. Rotate the inside lever. Operation should be smooth, and the latch should retract.
2. Insert the key into the keyway and rotate the key, or the key and lever to open the door.
Operation should be smooth, and the latch should retract.
Electronic test
Test the AD-400/AD-401 in factory default mode
1. For locks with a keypad, press any number key. The lock should beep.
2. Press the Schlage button. The keypad should light blue for a few seconds.
3. For locks with a card reader, present a credential to the reader. The lock will beep and
the Schlage button will blink red one time. When the lock is in factory default mode, no
credentials are accepted and the lock will respond with one red blink indicating the lock
is not linked with the PIM400.
4. Locks with keypads, with or without additional credentials, have a default PIN of 13579
and "#". To test, enter the default PIN. The Schlage button will blink and the lock will
unlock.
Test the AD-400/AD-401 in construction access mode
1. When the master construction credential is presented, the AD-400/AD-401 will beep and
the Schlage button will light green for 20 seconds awaiting the presentation of another
credential to be granted construction user access.
2. When a valid construction access user credential is presented, the lock will unlock for the
re-latch delay period (default three seconds), and the Schlage button will blink green.
When the lock
re-locks after the re-latch delay period, the Schlage button will blink red.
3. If an invalid construction access user credential is presented, the lock will beep and the
Schlage button will blink red one time. See Construction access mode on page 6 for
more information.
NOTE: Construction access mode is cancelled when the lock is either linked to a PIM400,
or reset to factory defaults. When construction access mode is cancelled, the master
construction credential and all other credentials added using the master construction
credential will no longer function.
Test with the AD-400/AD-401 linked to the PIM400 and Access Control Panel (ACP)
Once the AD-400/AD-401 is linked to the PIM400, the SUS will indicate a successful link.
The SUS will display AD-400/AD-401 operations and communication status with the PIM400.
1. In the SUS "demo/diagnostics" menu display for the PIM400, choose "Select door" and
set a door number for the lock being tested. The SUS will display operation and status
for: link, reader data, motor, tamper, battery, request-to-enter, request-to-exit and door
position switch.
If the SUS demo/diagnostics "UNLOCK ON READ" box is checked, all
L
credentials will unlock the AD-400/AD-401 during demo/diagnostics check.
2. Present a valid credential to the AD-400/AD-401. The Schlage button will blink green,
a beep will sound and the door will unlock for the preset lock delay period. The lock will
re-lock after the lock delay period and the Schlage button will then blink red.
3. If an invalid credential is presented, the Schlage button will blink red, a beep will sound
and the door will not unlock. Credential data for all credentials is reported to the PIM400
and displayed at the ACP.
Test lock operation
9 • Schlage • AD-400 user guide