Schlage PIB300 User Manual page 1280

Appendix D - Troubleshooting
Beeper and LED Status During Verification
58
This is called a "lockout." Before the rejected ID number can be used again, another
employee or a supervisor must successfully verify at the HandPunch.
• If you enter your ID number, but do not place your hand on the platen, the HandPunch
will time-out in about 25 seconds. You can immediately end this time-out by pressing
the CLEAR key.
The HandPunch's beeper and LED status display also display hand verification
information. This information is defined in Table 12.
Table 12: Beeper and LED Status During Verification
Operation
During Keypad 1 per Keystroke
Entry
After ID Entry –
After ID Entry 2
After Hand 1
Placement
After Hand 2
Placement
After Hand 1 Long
Placement Continuous
Beeps LED
–
–
–
Green
Red
Red
Meaning
Keystroke Accepted
OK - Proceed
ID Number Not in
Database
ID Verified
ID Not Verified -
Try Again
ID Refused