Xilinx MicroBlaze Reference Manual page 275

rtbd Return from Break
rA, IMM
rtbd
1 0 1 1 0 1 1 0 0 1 0
0
6
Description
Return from break will branch to the location specified by the contents of rA plus the IMM field, sign-
extended to 32 bits. It will also enable breaks after execution by clearing the BIP flag in the MSR.
This instruction always has a delay slot. The instruction following the RTBD is always executed before
the branch target. That delay slot instruction has breaks disabled.
When MicroBlaze is configured to use an MMU (C_USE_MMU >= 1) this instruction is privileged. This
means that if the instruction is attempted in User Mode (MSR[UM] = 1) a Privileged Instruction
exception occurs.
Pseudocode
if MSR[UM] = 1 then
←
ESR[EC]
else
←
(rA) + sext(IMM)
PC
allow following instruction to complete execution
←
MSR[BIP]
←
MSR[UM]
←
MSR[VM]
Registers Altered
• PC
• MSR[BIP], MSR[UM], MSR[VM]
• ESR[EC], in case a privileged instruction exception is generated
Latency
• 2 cycles
Notes
Convention is to use general purpose register r16 as rA.
A delay slot must not be used by the following: imm, branch, or break instructions. Interrupts and
external hardware breaks are deferred until after the delay slot branch has been completed.
MicroBlaze Processor Reference Guide
UG984 (v2018.2) June 21, 2018
rA
11
00111
0
MSR[UMS]
MSR[VMS]
www.xilinx.com
Chapter 5: MicroBlaze Instruction Set Architecture
IMM
16 31
276
Send Feedback