Xilinx MicroBlaze Reference Manual page 197

addi Arithmetic Add Immediate
rD, rA, IMM
addi
addic rD, rA, IMM
rD, rA, IMM
addik
addikc rD, rA, IMM
0 0 1 K C 0
0
6
Description
The sum of the contents of registers rA and the value in the IMM field, sign-extended to 32 bits, is
placed into register rD. Bit 3 of the instruction (labeled as K in the figure) is set to one for the
mnemonic addik. Bit 4 of the instruction (labeled as C in the figure) is set to one for the mnemonic
addic. Both bits are set to one for the mnemonic addikc.
When an addi instruction has bit 3 set (addik, addikc), the carry flag will keep its previous value
regardless of the outcome of the execution of the instruction. If bit 3 is cleared (addi, addic), then the
carry flag will be affected by the execution of the instruction.
When bit 4 of the instruction is set to one (addic, addikc), the content of the carry flag (MSR[C]) affects
the execution of the instruction. When bit 4 is cleared (addi, addik), the content of the carry flag does
not affect the execution of the instruction (providing a normal addition).
Pseudocode
if C = 0 then
←
(rD) (rA) + sext(IMM)
else
←
(rD) (rA) + sext(IMM) + MSR[C]
if K = 0 then
←
MSR[C] CarryOut
Registers Altered
• rD
• MSR[C]
Latency
1 cycle
Notes
The C bit in the instruction opcode is not the same as the carry bit in the MSR.
By default, Type B Instructions take the 16-bit IMM field value and sign extend it to 32 bits to use as
the immediate operand. This behavior can be overridden by preceding the Type B instruction with an
imm instruction. See the instruction
MicroBlaze Processor Reference Guide
UG984 (v2018.2) June 21, 2018
Add Immediate
Add Immediate with Carry
Add Immediate and Keep Carry
Add Immediate with Carry and Keep Carry
rD rA
11
"imm," page 241
www.xilinx.com
Chapter 5: MicroBlaze Instruction Set Architecture
IMM
16
for details on using 32-bit immediate values.
31
198
Send Feedback