Xilinx MicroBlaze Reference Manual page 116

Table 2-62: MicroBlaze Cross Trigger Actions
Number Action
0 Debug stop
1 Continue execution
2 Stop program trace
3 Start program trace
4 Stop performance
monitoring
5 Start performance
monitoring
6 Disable profiling
7 Enable profiling
Table 2-63: MicroBlaze Cross Trigger Events
Number
0 MicroBlaze halted
1 Execution resumed
2 Program trace
stopped
3 Program trace
4 Performance
monitoring stopped
5 Performance
monitoring started
6 Profiling disabled
7 Profiling enabled
MicroBlaze Processor Reference Guide
UG984 (v2018.2) June 21, 2018
Stop MicroBlaze if the processor is executing, and set the MB_Halted
output. The same effect is achieved by setting the
Continue execution if the processor is stopped, and clear the
MB_Halted output.
Stop program trace if tracing is in progress.
Start program trace if trace is stopped.
Stop performance monitoring if it is in progress.
Start performance monitoring if it is stopped.
Disable profiling if it is in progress.
Enable profiling if it is disabled.
Event
Generate an event when MicroBlaze is halted. The same event is signaled
when the MB_Halted output is set.
Generate an event when the processor resumes execution from debug
halt. The same event is signaled when the
Generate an event when program trace is stopped by writing a command
to the Program Trace Command Register, when the trace buffer is full, or
by a cross trigger action.
Generate an event when program trace is started by writing a command
started
to the Program Trace Command Register, by hitting a tracepoint, or by a
cross trigger action.
Generate an event when performance monitoring is stopped by writing
a command to the Performance Counter Command Register or by a cross
trigger action.
Generate an event when performance monitoring is started by writing a
command to the Performance Counter Command Register, or by a cross
trigger action.
Generate an event when profiling is enabled by writing a command to
the Profiling Control Register or by a cross trigger action.
Generate an event when profiling is disabled by writing a command to
the Profiling Control Register or by a cross trigger action.
www.xilinx.com
Chapter 2: MicroBlaze Architecture
Description
Dbg_Stop input.
Description
MB_Halted output is cleared.
Send Feedback
116