Chapter 2: Managing Switch
DHCP Server
Item
DHCP Server
Apply
Restart
112
PoE Port Status
To access this page, click Management > Power Over Ethernet > PoE
Port Status. This window is informational only.
The PoE Port Status settings in the ensuing table are informational only:
Port, Current (mA), Voltage (V), Power (W) and Temp. (°C).
The Dynamic Host Configuration Protocol (DHCP) is a network protocol
enabling a server to automatically assign an IP address to a computer
from a defined range of numbers configured for a given network.
Status Settings
The Status Settings page allows you to configure the DHCP server mode
(enabled or disabled).
To access this page, click Management > DHCP Server > Status
Settings.
Figure 97. Management > DHCP Server > Status Settings
The following table describes the items in Figure 97.
Table 93. Status Settings
Description
Select Enable or Disable to designate the DHCP server function
type.
When a new DHCP server mode is selected, the switch requires a
system restart for the new mode to take effect.
Click Apply to save the values and update the screen.
Click Restart to have the switch perform a system restart function. In
the event that the IP settings are changed, the DHCP server must be
restarted for the IP settings to take effect.
The Status Information settings in the ensuing table are informational
only: DHCP Server Service.