Show Interface Status; Table 15. Show Interface Status Command - Allied Telesis AT-8100L/8 User Manual

Chapter 10: Port Parameter Commands

SHOW INTERFACE STATUS

PortNameStatus
port1.0.1Port_01down3
port1.0.2Port_02up11
port1.0.2Port_02up2
port1.0.2Port_02up2
port1.0.2Port_02up2
234
Syntax
port
show interface [
Parameter
port
Specifies the port whose parameter settings you want to view. You
can display more than one port at a time. To display all the ports,
do not include a port number.
Modes
Privileged Exec mode
Description
Use this command to display the speed, duplex mode, and VLAN settings
of the ports. An example of the information is shown in Figure 56.
Vlan Duplex
half
auto
auto
full
auto
Figure 56. SHOW INTERFACE STATUS Command
The fields are described in Table 15.

Table 15. SHOW INTERFACE STATUS Command

Parameter
Port
Name
Status
VLAN
] status
SpeedType
10010/100/1000Base-T
auto10/100/1000Base-T
auto10/100/1000Base-T
10010/100/1000Base-T
auto10/100/1000Base-T
Description
Port number.
Description of port. To set the description,
refer to "DESCRIPTION" on page 204.
Link status of the port. The status is Up if
the port has a link to a network device.
The status is Down if the port does not
have a link.
The ID of the VLAN in which the port is an
untagged member.