Table of Contents
Advertisement
LEDs
Status LEDs
The following sections describe the LEDs on the switches:
"Status LEDs" on page 35
"Twisted-Pair Port LEDs" on page 36
"SFP Slot LEDs" on page 37
"PoE Status LEDs" on page 37
The status LEDs are defined in Table 6.
LED
State
Solid Green
SYS
Off
Solid Green
MASTER
Off
Solid Green
PWR 1
Off
Solid Green
PWR 2
Off
Solid Red
FAULT
Off
IS230-10GP Industrial Ethernet Layer 2 Switch Installation Guide
Table 6. Status LEDs
Description
System is operating normally
System is powered down, there is a system
crash or an operation is initiating.
Active when switch is the Ring Master of an
X-Ring configuration
Switch is not the Ring Master of an X-Ring
configuration
The switch is receiving power on the PWR 1
connector contacts and is operating
normally.
The PWR 1 supply is powered down or is
not installed.
The switch is receiving power on the PWR 2
connector contacts and is operating
normally.
The PWR 2 supply is powered down or is
not installed.
Defined major Alarm policy is triggered. See
"P-Fail Alarm Relay Contacts" on page 33
for more information.
System the system is operating normally or
is powered OFF.
35
Advertisement
Table of Contents
