Network Monitoring Commands - D-Link DES-3550 Command Line Interface Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show packet ports
show error ports
show utilitzation
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config system_severity
show system_severity
Each command is listed, in detail, in the following sections.
DES-3550 Layer 2 Fast Ethernet Switch
N
ETWORK
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
ports <portlist>
index <value>
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number>| state [enable | disable]
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable | disable]}
[<index 1-4> | all]
<index 1-4>
[[all | trap | log] [critical | warning | information]]
75
M
ONITORING
9
C
OMMANDS