Chapter 22 Digital Diagnostic Monitoring (Ddm) Commands - D-Link DGS-1510/ME Series Reference Manual

Chapter 22 Digital Diagnostic Monitoring
config ddm [trap | log] [enable | disable]
config ddm ports [<portlist> | all] [[temperature_threshold | voltage_threshold | bias_current_threshold |
tx_power_threshold | rx_power_threshold] {high_alarm <float> | low_alarm <float> | high_warning <float> |
low_warning <float>} | {state [enable | disable] | shutdown [alarm | warning | none]}]
show ddm
show ddm ports {<portlist>} [status | configuration]
22-1 config ddm
Description
The command configures the DDM log and trap action when encountering an exceeding alarm or warning
thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap - Specifies whether to send traps, when the operating parameter exceeds the corresponding threshold. The
DDM trap is disabled by default.
log - Specifies whether to send a log, when the operating parameter exceeds the corresponding threshold. The
DDM log is enabled by default.
enable - Specifies to enable the log or trap sending option.
disable - Specifies to disable the log or trap sending option.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure DDM log state to enable:
DGS-1510-28XMP/ME:admin# config ddm log enable
Command: config ddm log enable
Success.
DGS-1510-28XMP/ME:admin#
To configure DDM trap state to enable:
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
(DDM) Commands
204