Led Error Indications - Avaya DECT R4 Installation And Administration Manual

Troubleshooting
Display shows
Voice mail number not
defined
Could not encrypt connection

LED error indications

See chapter LED indications
LED is flashing red, quick flash, (100 ms on, 800 ms off)
If a third telephone, that is an other telephone than the "old" and "new" telephone
●
mentioned in
Replacement, this error indication appears. Change to the correct telephone.
The charger has found that Easy Replacement does not work. Change back to the "new"
●
telephone.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both telephones need to be sent for service.
686
Avaya DECT R4 - Installation and Maintenance Guide
Probable cause
There is no Voice mail
number defined in the
telephone.
The parameter "Encryption
Required" is enabled in the
telephone in combination
with:
1. Unencrypted base
station(s); and/or,
2. Unsupported base
station(s).
on page 245.
Definitions on page 210, is inserted into the charger during Easy
Action or comment
Define a Voice mail number
via the PDM/AIWS:
Systems >System A >
PBX Settings > Numbers.
1. Disable the "Encryption
Required" parameter in
telephone; and/or,
2. Enable the encryption in
the base station(s); and/or,
Note: If Avaya's base
station(s) is used, the
software version must be
3.1.x or greater.
3. Use supported base
station(s). Ask your supplier.
02/2016