Man-down alarm - Determines if the Man-down alarm shall be enabled or disabled.
●
Man-down detection time - Determines when the warning phase will start after
●
man-down is triggered.
No-movement alarm - Determines whether the No-movement alarm shall be enabled or
●
disabled.
No-movement detection time - Determines when the warning phase will start after
●
No-movement alarm is triggered.
Warning phase duration - Determines the time before the warning phase is ended and
●
the alarm is sent.
ALS - Acoustic Location Signal enabled.
●
Mode for automatic call after alarm - The call can be established in the following modes:
●
Off: No automatic call after alarm.
●
Normal: The call is established as an ordinary call.
●
Loudspeaking: The loudspeaker on the backside of the handset is turned on.
●
For additional parameter settings, see
Messaging settings
You can configure how incoming messages shall be indicated and displayed in telephone.
The parameters that can be found at Settings > Sound and Alerts:
Vibrate alert - Determines if the telephone shall vibrate when receiving incoming calls and
●
messages.
Message alert - Determines the message sound for incoming messages.The parameters
●
that can be found at Settings > Messaging:
Message alert during a call- Determines the message sound for incoming messages. It is
●
possible to select a predefined melody (Message 1 - Message 7) or a beep code that
represents a certain sound.
Text size - Size of the message text when viewing and writing messages.
●
Message alert during call - Determines if a message alert should be played when receiving
●
a message during a call.
Message volume - Determines the message volume for incoming messages. By default,
●
the message volume follows the ring volume, but another message volume can be set with
this parameter.
Vibrator for message during call - Determines if the handset shall vibrate when receiving
●
messages during an ongoing call. The Vibrate alert parameter must also be enabled if the
handset shall vibrate when receiving a message during the call.
Avaya DECT R4 - Installation and Maintenance Guide
Common alarm settings
Telephone configuration
on page 233.
02/2016
235