Fcc Compliance Statements For Class B Digital Device - Avaya DECT R4 Installation And Administration Manual

Memory
SDRAM
NAND Flash
Serial data flash
SD card(currently not supported- for future use
only)

FCC Compliance statements for Class B Digital device

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is
●
connected.
Consult the dealer or an experienced radio or television technician for help.
●
Information to user
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
this device may not cause harmful interference, and this device must accept any
●
interference received, including interference that may cause undesired operation.
●
Modifications
Changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Avaya DECT R4 - Installation and Maintenance Guide
Capacity
256 MB
1 GB for software application
8 MB for booting purposes
1 slot for 1 GB SD card
Introduction
559
02/2016