Maintenance Information For The Aiws2 - Avaya DECT R4 Installation And Administration Manual

Installing Elise 3 Server (AIWS2 Hardware)
The data is sent to the System 900 interface (127.0.0.1/S900) in the Elise 2 Server (AIWS Hardware)
and is then sent to the module with address 03 in the system. It is also possible to address the System
900 interface on another module by entering its IP address instead of 127.0.0.1(localhost)
.Addressing another Unite compliant module on the LAN
The addressing includes the IP address that the data should be distributed to and also which
service on that address that should take care of it. How a unit is addressed is described in each
units documentation.
Addressing of another Unite compliant module
●
xxx.xxx.xxx.xxx/Service
First the IP address of the module is defined. After the "/", the application service that
should take care of the data is specified.
Below is an example that describes how to distribute data from an Elise 2 Server (AIWS
Hardware) software application to an Alarm Management Server.
Addressing of an Alarm Management Server
●
xxx.xxx.xxx.xxx/EventHandler
First the Alarm Management Server IP address is defined. After the "/", the application
service EventHandler is specified.
Note:
For AMS version 3.00 and 3.10 the service cannot be used. Instead the correct
Note:
port on the AMS, port number 10010, has to be used for addressing, i.e.
xxx.xxx.xxx.xxx/:10010.

Maintenance information for the AIWS2

Software management -
Installation of software
Normally the installation of software is done from the application's web interface but it can also
be done in Boot Mode, see
administration on the AIWS2
590
Avaya DECT R4 - Installation and Maintenance Guide
Installing software in boot mode
on page 507.
on page 592. See also Software
02/2016