Operation; Charger Operation - Avaya DECT R4 Installation And Administration Manual

Installing and operating the Rackmount Charger
4. Go to the Devices tab and verify that the Rackmount Charger is online (it may take up to
15 sec).
If you are using PDM:
1. Check that the Rackmount Charger is connected to your PC.
2. Start PDM.
3. Go to the Devices tab and verify that the Rackmount Charger is online.
For instructions on how to verify that the charger parameter setting works, and for further
instructions, please see
page 315, or Devices

Operation

Charger operation

When the charger is connected to external power supply, normal operation is done as follows:
Telephone charging
1. Connect the charger to the AC power supply.
2. Place a telephone in the charging slot to start charging.
Telephone disconnection
1. First, tilt the telephone forwards.
2. Then, lift the telephone upwards.
Note:
Do not try to lift the telephone upwards before tilting it forwards.
Note:
If the charger is connected to PDM/AIWS, the following operations can be done:
Software upgrade of charger or handset
●
Parameter settings of charger or handset
●
See Installing and operating the Portable Device Manager (WinPDM)
Devices
Easy Replacement of handset
●
Phonebook upload (handset)
●
310
Avaya DECT R4 - Installation and Maintenance Guide
Installing and operating the Portable Device Manager (WinPDM)
on page 417.
on page 417, for details.
on
on page 315, or
02/2016