Avaya DECT R4 Installation And Administration Manual page 304

Installing and operating the Rackmount Charger
2. Connect the mains power supply cord to the disconnect device.
The IEC color code is used in the power cord supplied.
Colors
IEC US
Brown Black
Blue White
Gr/Ye ** Green
* The "Old" standard was used in various countries (including Australia),
and some wiring may still use these colors.
** Gr/Ye - Green with Yellow stripe - this is the standard world wide,
although it is not common in the US or Canada at present.
*** There is an important distinction between "Grounding conductor"
(safety earth) and "Grounded conductor" (Neutral). These are US
terms for the conductors and they are not interchangeable, despite the
similarity of the names !
Installation of additional units in a serial power configuration
Note:
Maximum five units may be connected in power series.
Note:
Note:
Maximum four units may be connected in LAN series to one single LAN outlet.
Note:
!
Important:
It is not allowed to connect additional Rack Chargers or Battery Pack chargers if
Important:
the chargers are connected to the power supply via an AC plug.
!
Important:
Disconnect the power supply connection before working on the units.
Important:
1. If the additional Rack Charger has not yet been mounted on the wall, do this according to
figure 73
2. Open the top cover of the rack charger closer to the AC power source.
304
Avaya DECT R4 - Installation and Maintenance Guide
Old *
Red
Black
Green
on page 303.
Load Also called
Active Line, Hot
Neutral Return, Cold, Grounded connector
Earth Ground, Safety Earth, Earth Ground,
Grounding conductor ***
02/2016