Lan - Avaya DECT R4 Installation And Administration Manual

Installing and operating the IPBS and IPBL
2
3
For more information about certificate handling, see
Provisioning Modes
There are three different modes.
Active
Inactive
Not connected

LAN

This section describes how to do the following configurations and settings.
Set DHCP mode
●
Set IP static address
●
Set dynamic IP address
●
Set link type
●
Configure VLAN
●
Enable RSTP (only for IPBL)
●
View LAN statistics
●
Note:
The IPBL has two LAN ports. LAN1 port must be used in the IP-DECT system
Note:
and LAN2 port must be used for administration only.
Setting DHCP mode
The IPBS/IPBL can have the following DHCP modes:.
Off
Client
Automatic
140
Avaya DECT R4 - Installation and Maintenance Guide
In the Rejected certificates section select the check box of the certificate you want to trust.
Click "Trust".
The connection is up.
Provisioning is not enabled for the currently viewed IPO PBX or the
connection is used for the other IPO PBX.
Provisioning is enabled for the currently viewed IPO PBX but the
connection cannot be established or the connection is being established.
Used if the IPBS/IPBL has a static IP address.
Acts as a DHCP Client, if there is a DHCP server in the network it will
be assigned an IP address
Acts as a DHCP client on start up.
If you reset he IPBS/IPBL by pressing the reset button, it will get the IP
address 192.168.0.1 and the netmask 255.255.255.0 for the LAN port.
Creating a certificate on page 385.
02/2016